WeatherShield®

For In-Line Connectors, Antennas and Tower Top Devices

Complete your transmission line installation with Andrew’s WeatherShield Connection Protection Enclosure which seals and protects connectors from the environment. This robust, one-piece weatherproofing enclosure offers an additional measure of system protection by providing a high-temperature resistant, watertight seal around the connectors while also helping to dampen vibration that can loosen connector interfaces over time.

The reusable enclosure contains an innovative trifold seal that provides complete moisture block for installed connectors. The ease of installation on hard-to-reach connections and the long-term protection provided by this enclosure makes it the most cost-effective solution available today.

The WeatherShield Connection Protection Enclosure takes just seconds to install. Simply place the housing around the connector and snap the tabs together. No tapes, tools, or shrink tubes are required.

• Reusable, one-piece design
• Cost-effective alternative to tapes and shrink tubes
• Installs easily, even in the harshest weather environments
• IP 68 rating ensures an effective barrier against ingress of water
• Clean removal
• Fits over connected interfaces
• Helps maintain interface coupling torque
• Fits popular cable brands
• Useable for maintenance of older sites
• Three year warranty

Quickly Installs in Three Minutes

Complete your transmission line installation with the premier weatherproofing product to seal and protect connectors, splices, surge protectors, and jumper-to-antenna interfaces from the environment. Andrew 3M™ Cold Shrink™ weatherproofing protects your investment and your system’s performance.

No Tools Required

Cold Shrink weatherproofing simply slips over the connection and compresses around the interface. No tapes or heat guns are required for sealing or shrinking. Simply place the Cold Shrink kit over the cable and connector, make the connection, and unwind the pull-tab applicator. Once it is collapsed, its continuous compression design forms a watertight seal around the cable. Developed jointly by Andrew and 3M™ Corporation, Cold Shrink weatherproofing has proven itself in thousands of high power cable installations for more than 15 years.

Fits up to 2-1/4 in HELIAX® Cable

Kits are available for transitions from larger to smaller diameter cable, such as 1-5/8 in to 1/2 in, or for same diameter cable, such as 1/2 in to 1/2 in. See the table for part numbers.

3M and Cold Shrink are trademarks of Minnesota Mining and Manufacturing Company